Steam Sensor
  • Steam Sensor
  • Steam Sensor

Steam Sensor

0 Review
Tax included

  • Política de segurança Política de segurança
  • Política de entrega Política de entrega
  • Política de devolução Política de devolução
This is a steam(water)sensor from DFRobot. This steam sensor can be connected to the Arduino IO Expansion shield directly. The output voltage will increase when the humidity of the sensor surface goes up.
Notice:The new version of analog sensor port pin mapping has been changed as the following two features.


Warning: The connector is not waterproof, please be careful not to put the connector directly in water. 


  • Simple rain detector
  • Cheap steam level switch
  • Touch sensor based on humidity



  • Power supply: 3.3v or 5v
  • Output voltage signal: 0~4.5v(@5v) or 0~3.0v(@3.3v)
  • Pin definition:
  • Analog output(Blue wire)
  • GND(Black wire)
  • Power(Red wire)
  • Size: 30x20x6mm (0.18x0.79x0.24")

No customer reviews for the moment.

Add a review

Your email address will not be published.Required fields are marked*

Related Products