Filtrar por
Shield WiFi CC3000 para...
Este é um shield para o Módulo WiFi CC3000. O CC3000 da TI (Texas Instruments) é um processador de rede sem fio independente que faz incorporar conectividade com a Internet em seu projeto. Em vez de o método de comunicação UART padrão, o módulo CC3000 utiliza uma interface SPI permitindo que você posssa controlar o fluxo de dados como quiser.
Arduino Ethernet Shield 2 -...
The Arduino Ethernet Shield 2 connects your Arduino to the internet in mere minutes.
without PoE version
Arduino GSM/GPRS Shield
The GPRS/GSM Shield provides you a way to use the GSM cell phone network to receive data from a remote location. The shield allows you to achieve this via any of the three methods:
- Short Message Service
- Audio
- GPRS Service
ITEAD Bluetooth Wireless...
BT shield (salve) is a HC-06 serial port Bluetooth module breakout board for Arduino, you can directly use the BT shield (salve) with Arduino UART port for Bluetooth communication.
IComSat GSM / GPRS SIM900...
IComsat is a GSM/GPRS shield for Arduino and based on the SIM900 Quad-band GSM/GPRS module. It is controlled via AT commands (GSM 07.07 ,07.05 and SIMCOM enhanced AT Commands), and fully compatible with Arduino / Iteaduino and Mega.
ITEAD Bluetooth Low Energy...
BLE shield is to adapt Bluetooth Low Energy to serial port, which is specifically designed for Arduino motherboard and compatible boards, plug and play.
DFRduino Ethernet w5100...
This version of Ethernet Shield is not only compatible with Mega 1280 and 2560, but also provides a Micro SD card slot for reading/writing.
DTMF Shield
This DTMF Shield is a Dual-tone multi-frequency signaling module decoder for Arduino With it's audio connector you can decode the crazy funny noises common phones make.