Acelerómetros arduino


Produtos visualizados


Não existe um feed RSS disponível

Itead ADXL33 Ver maior

Itead ADXL335


Novo produto

Itead ADXL335 

Mais detalhes

Aviso: Últimos itens disponíveis!

7,26 € com IVA

Adicionar à Lista de desejos

Mais informação

Itead ADXL335 Module

The ADXL335 is a small, thin, low power, complete 3-axis accelerometer with signal conditioned voltage outputs. The product measures acceleration with a minimum full-scale range of ±3 g. It can measure the static acceleration of gravity in tilt-sensing applications, as well as dynamic acceleration resulting from motion, shock, or vibration.






Operation Level


Power Supply

External 3.3V




 Reads an Analog Devices ADXL3xx accelerometer and communicates the
 acceleration to the computer.  
The circuit: analog 0: accelerometer self test analog 1: z-axis analog 2: y-axis analog 3: x-axis analog 4: ground analog 5: vcc created 2 Jul 2008 by David A. Mellis modified 30 Aug 2011 by Tom Igoe This example code is in the public domain. */ // these constants describe the pins. They won't change: const int groundpin = 18; // analog input pin 4 -- ground const int powerpin = 19; // analog input pin 5 -- voltage const int xpin = A3; // x-axis of the accelerometer const int ypin = A2; // y-axis const int zpin = A1; // z-axis (only on 3-axis models) void setup() { // initialize the serial communications: Serial.begin(9600); // Provide ground and power by using the analog inputs as normal // digital pins. This makes it possible to directly connect the // breakout board to the Arduino. If you use the normal 5V and // GND pins on the Arduino, you can remove these lines. pinMode(groundpin, OUTPUT); pinMode(powerpin, OUTPUT); digitalWrite(groundpin, LOW); digitalWrite(powerpin, HIGH); } void loop() { // print the sensor values: Serial.print(analogRead(xpin)); // print a tab between values: Serial.print("t"); Serial.print(analogRead(ypin)); // print a tab between values: Serial.print("t"); Serial.print(analogRead(zpin)); Serial.println(); // delay before next reading: delay(100); }




Clientes que compraram este produto também compraram: