RFID & NFC

Promoções

Produtos visualizados

NFC thin smart card tag tags Mifare 1k S50 IC 13.56MHz Read & Write RFID Ver maior

Mifare NFC tag smart card fina 13,56MHZ leitura e gravação RFID

BE15000013

Novo produto

1,72 € com IVA

Adicionar à Lista de desejos

Mais informação

MiFare Classic - 13.56MHz RFID NFC Card - 1KB
This is a blank MiFare Classic card - often used for train/bus passes but also found in other systems where a proximity card is desired. The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.
These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!
These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.

Technical Details


S50 chip specification:

  • 1 KiloByte (8 KiloBit) non-volatile EEPROM storage

  • Built in encryption engine with 48-bit key

  • 4 Byte unique identifier burned into the chip

  • 13.56 MHz frequency

 

Tag specification:

  • 85.5mm x 54mm x 1mm /3.36" x 2.1" x 0.03"

  • 6.3 grams / 0.2 oz

  • Works about 4" away from reader

Acessórios

Clientes que compraram este produto também compraram: