PIR Motion Sensor
  • PIR Motion Sensor

Sensor de movimento PIR HC-SR501

0 Review
4,60 €

PIR Motion Sensor


Pin-out and Instruction Pamphlet
Technical Specifications:
Working Voltage : 5 VDC to 20 VDC
(recomended between 5 VDC and 12 VDC for thermal considerations).
Output voltage: 3.3V (LVTTL) transistor may be used to change output
Simple One Wire Device
Startup Time: 2 Seconds to get a measure on room volume
Left Knob: Controls output latch delay (Between left-most 2 and right-most 300 seconds)
Right Knob: Controls center of best detection (Between left-most 3M and right-most 7M)

Out Pin: High means the environment has changed (intruder, dog, etc…) Low means it will keep checking.



 * PIR sensor tester
int ledPin = 13;                // choose the pin for the LED
int inputPin = 2;               // choose the input pin (for PIR sensor)
int pirState = LOW;             // we start, assuming no motion detected
int val = 0;                    // variable for reading the pin status
void setup() {
  pinMode(ledPin, OUTPUT);      // declare LED as output
  pinMode(inputPin, INPUT);     // declare sensor as input
void loop(){
  val = digitalRead(inputPin);  // read input value
  if (val == HIGH) {            // check if the input is HIGH
    digitalWrite(ledPin, HIGH);  // turn LED ON
    if (pirState == LOW) {
      // we have just turned on
      Serial.println("Motion detected!");
      // We only want to print on the output change, not state
      pirState = HIGH;
  } else {
    digitalWrite(ledPin, LOW); // turn LED OFF
    if (pirState == HIGH){
      // we have just turned of
      Serial.println("Motion ended!");
      // We only want to print on the output change, not state
      pirState = LOW;

No customer reviews for the moment.

Add a review

Your email address will not be published.Required fields are marked*

Clientes que compraram este produto também compraram:

Relacionados Produtos