MPX5010dp Freescale
  • MPX5010dp Freescale

Pressure Sensor MPX5010dp Freescale

0 Review
23,37 €



  • Política de segurança Política de segurança
  • Política de entrega 24/48H Política de entrega 24/48H
  • Política de devolução Política de devolução

This sensor detects changes in air pressure at its two ducted ports. The output of the sensor is an analog voltage that varies depending on the pressure.   The pressure sensor can detect changes in both positive and negative air pressure. Positive air pressure is equivalent to blowing into a tube. Negative air pressure creates a vacuum, similar to sucking from a straw.



To connect the pressure sensors to the Arduino Shield, attach the three leads of the device as shown in the figure. The sensor is a 6-pin device, but only pins 1-3 are connected. Note that pin 1 is denoted by a small notch. 


Although the leads on the pressure have the standard 0.100" spacing, it is recommended that you connect the device to the Arduino using male-female jumper wires, rather than plugging the sensor directly into the breadboard of the Arduino Shield. This allows you more flexibility in connecting tubes to the sensor.



// Pin 1 (notch) - Analog output
// Pin 2 - Gnd
// Pin 3 - 5V

int sensorPin = A0;    // Select input pin for the potentiometer
int sensorValue = 0;   // Variable stores value coming from the sensor

void setup() {

void loop() {
  sensorValue = analogRead(sensorPin);  // Read sensor
  Serial.println(sensorValue, DEC);     // Display result
  delay(400);         // Wait 400 milliseconds


Pressure Sensor MPX5010dp Freescale


No customer reviews for the moment.

Add a review

Your email address will not be published.Required fields are marked*

Clientes que compraram este produto também compraram:

Relacionados Produtos