Prototyping Shield for Raspberry Pi 2_3 /Model A+/Model B+
  • Prototyping Shield for Raspberry Pi 2_3 /Model A+/Model B+

Shield de Prototipagem para Rapberry Pi

0 Review
9,80 €
Com IVA
BE15000753
Quantidade
Últimos artigos em stock

  • Política de segurança Política de segurança
  • Política de entrega 24/48H Política de entrega 24/48H
  • Política de devolução Política de devolução

This a Raspberry Pi prototyping shield. You can stack it on your Raspberry Pi easily. which can snap onto the Pi main board assembly (and is removable later if you wish) and gives you all sorts of prototyping goodness to make building on top of the Pi super easy.

 We added lots of basic but essential goodies. First up, there's a big prototyping area, half of which is 'breadboard' style and half of which is 'perfboard' style so you can wire up DIP chips, sensors, and the like. Along the edges of the proto area, all the GPIO/I2C/SPI and power pins are broken out to 0.1" stips so you can easily connect to them. On the edges of the prototyping area, all of the breakout pins are also connected to labeled 3.5mm screw-terminal blocks. This makes it easy to semi-permanently wire in sensors, LEDs, etc. There's also a 4-block terminal block broken out to 0.1" pads for general non-GPIO wiring. Finally, we had a little space remaining over the metal connectors so we put in an SOIC surface mount chip breakout area, for those chips that dont come in DIP format.

Tinysine
BE15000753

No customer reviews for the moment.

Add a review

Your email address will not be published.Required fields are marked*

Clientes que compraram este produto também compraram:

Relacionados Produtos